FIRERAY 5000 Multi Head Auto Aligning Infrared Optical Beam Smoke Detector

FIRERAY 5000 is ideally suited for the protection of large areas where the use of traditional detection technologies would prove to be too difficult and/ or costly to install. The FIRERAY 5000 combines an infrared transmitter and receiver in the same discrete unit and operates by projecting a well-defined beam to a reflective prism, which returns the beam to the receiver for analysis. Smoke in the beam path causes a drop in power, which, if below a pre-determined level, results in an alarm signal. The system can be fully customised, according to local conditions; both alarm thresholds ( sensitivity) and time to Alarm/ Fault can be set from the ground level System Controller. Each detector head is independently configurable from 8m through to 100m and has its own individual fire threshold. The System Controller retains one set of Fire and Fault relays that is common to all detectors that are installed. The FR5000 MultiHead is supplied with one detector head and reflector for single beam operation from 8 to 50 meters. Up to 3 additional detector heads can be added to the controller to enable larger or more complex areas to be protected ( Subject to local codes and standards) . The Fireray 5000 when used in its low power mode can be interfaced to the MZX Fire Controller using the BDM800 module. Products Name and Code: 516.015.020 FireRay 5000 System ( 50m) 516.015.021 FR 5000 Detector Head ( 50m) 516.015.007 FireRay Reflector 100 x 100mm. 4 reflectors are required for distances from 50 to 100m.